Wipe the previously cleaned areas dry with a dry, lint-free cloth. Use a fresh, lightly dampened, lint-free cloth to wipe the plastic ramps on both sides, away from the nozzles. Use a fresh, lightly dampened, lint-free cloth to wipe any accumulated ink and debris from the edge between the nozzles and the contacts. Use as many fresh, lightly dampened, lint-free cloths as necessary. Use a fresh, lightly dampened, lint-free cloth to wipe the electrical contact area from the bottom to the top until no new ink shows on the cloth. Plastic ramp on the side of the ink nozzles Touch the electrical contact areas only with the cleaning materials. CAUTION:ĭo not touch the nozzles or the electrical contacts with your fingers. Review the three areas of the printhead that need to be cleaned. Lift up to remove the printhead from the ink carriage. Lift the latch handle on the ink carriage until it stops. Doing so can result in damage to both the printer and the ink cartridges. CAUTION:ĭo not leave the ink cartridges outside the printer longer than 30 minutes. Place the ink cartridges on a clean piece of paper with the ink opening face up. Press the tab on the front of the ink cartridge to release it, and then remove it. If the printhead cleaning tool did not resolve the problem, the printhead might be installed incorrectly, or there might be ink or debris on the printhead electrical contacts.ĭo not use tap water because it might contain contaminants that can damage the printhead.
0 Comments
Leave a Reply. |